Loops underneath your fabric? Bobbin thread showing on top? Before you start turning the tension dial, check the threading, bobbin, and needle. A small setup problem can look like a much bigger one.
For ordinary straight-stitch sewing, balanced tension means the upper and bobbin threads meet inside the fabric layers, leaving a smooth, secure seam. Your machine’s manual is the best guide for its threading path and starting settings.
What Are Your Stitches Telling You?
Loose loops underneath: Check the upper threading first. A missed take-up lever or thread that has not seated between the tension discs can cause a mess below.
Bobbin thread showing on top: Check the bobbin’s direction and threading path. If those are correct, the upper tension may be too tight.
Puckering, skipped stitches, or breaking thread: These are not always tension problems. Check for a damaged or unsuitable needle, snagged thread, or a fabric-and-thread mismatch.
Start With These Simple Checks
1. Clear any tangles safely. Switch off the machine before working around the needle or bobbin. Cut tangled threads and remove them gently. Never force the fabric or handwheel.
2. Rethread the upper thread. Raise the presser foot to release the tension discs, and bring the take-up lever to its highest position as your manual directs. Rethread every guide, including the take-up lever and the guide above the needle. Lower the foot before sewing.
3. Check the bobbin. Use the exact bobbin type your machine requires. Make sure it is wound evenly, inserted in the correct direction, and threaded through the required slot or tension spring.
4. Replace the needle and brush out lint. Install a fresh needle of the correct type and size, facing the right direction. Brush lint from the user-accessible bobbin area according to your manual. Avoid compressed air and oil only where instructed.



Adjust the Tension a Little at a Time
Return the upper tension to your manual’s recommended starting setting. There is no single correct number for every machine.
Test on scraps using the same fabric, thread, stitch, and layers as your project. For quilting, include the batting and backing. Two contrasting colors of the same thread type and weight make it easier to see which thread is being pulled through.
Once threading is correct, make the smallest practical adjustment: increase upper tension for loose upper-thread loops underneath; decrease it if bobbin thread is pulled onto the top. Sew another test line and check both sides. Change only one setting at a time.
Label each test line with its setting so you can compare the results. When the seam lies flat and the stitches hold securely, test again with your project’s actual threads.



When to Stop Adjusting
Leave the bobbin-tension screw alone unless your manual gives a specific procedure. Random adjustments can create a second problem.
If correct threading, a fresh needle, a clean bobbin area, and small upper-tension adjustments do not help, have a qualified technician check the machine. Stop sooner for grinding, repeated needle strikes, visible damage, or a jam you cannot safely clear.



Keep a successful test sample beside your machine, labeled with the needle, thread, and setting. It gives you a useful starting reference next time.
For more help, visit our guide to quilting on a regular sewing machine or browse the Nancy’s Notions sewing and quilting library.
Leave a Reply